2013 Audi Q7 Oil Type & Capacity

The 2013 Audi Q7 oil type depends on the engine: the 3.0L takes 5W-40 (7.2 quarts with filter); the 3.0L takes 5W-40 (7.2 quarts with filter); the 3.0L takes 0W-30 (8.1 quarts with filter); the 3.0L takes 5W-40 (7.2 quarts with filter); the 3.0L takes 5W-40 (7.2 quarts with filter); the 3.0L takes 0W-30 (8.1 quarts with filter); the Prestige takes 0W-30 (8.1 quarts with filter); the Prestige S, Eng CD CJWB takes 5W-40 (7.2 quarts with filter); the Prestige S, Eng CD CTWA takes 5W-40 (7.2 quarts with filter), per the factory service manual.

Factory-spec answer

It depends on the engine:

Oil capacity by engine

EngineOil Type (viscosity)Capacity w/ FilterCapacity w/o FilterNotes
3.0L — GasSAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043.7.20 QTS.Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill.
3.0L — GasSAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043.7.20 QTS.Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill.
3.0L — DieselSAE 0W-30 High Performance Engine Oil 504.00 / 507.008.10 QTS.
3.0L — GasSAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043.7.20 QTS.Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill.
3.0L — GasSAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043.7.20 QTS.Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill.
3.0L — DieselSAE 0W-30 High Performance Engine Oil 504.00 / 507.008.10 QTS.
Prestige — DieselSAE 0W-30 High Performance Engine Oil 504.00 / 507.008.10 QTS.
Prestige S, Eng CD CJWB — GasSAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043.7.20 QTS.Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill.
Prestige S, Eng CD CTWA — GasSAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043.7.20 QTS.Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill.

Buy the right oil

Buy 5W-40 motor oil on AmazonBuy 0W-30 motor oil on Amazon2013 Audi Q7 oil filter on Amazon

As an Amazon Associate we earn from qualifying purchases made through these links.

More specs & repair guides for your Q7

2013 Audi Q7 factory service manualAll fluid capacities (transmission, coolant, brakes)

Powered by factory manual data from our partner site AllOEMManuals.com.

Coolant capacity

15.8 quarts (14.95 L). Part No. G 012 A8G.

Frequently asked questions

What type of oil does a 2013 Audi Q7 take?

It depends on the engine: 3.0L uses 5W-40; 3.0L uses 5W-40; 3.0L uses 0W-30; 3.0L uses 5W-40; 3.0L uses 5W-40; 3.0L uses 0W-30; Prestige uses 0W-30; Prestige S, Eng CD CJWB uses 5W-40; Prestige S, Eng CD CTWA uses 5W-40.

How much oil does a 2013 Audi Q7 take?

Capacity depends on the engine: 3.0L holds 7.2 quarts with filter; 3.0L holds 7.2 quarts with filter; 3.0L holds 8.1 quarts with filter; 3.0L holds 7.2 quarts with filter; 3.0L holds 7.2 quarts with filter; 3.0L holds 8.1 quarts with filter; Prestige holds 8.1 quarts with filter; Prestige S, Eng CD CJWB holds 7.2 quarts with filter; Prestige S, Eng CD CTWA holds 7.2 quarts with filter.

Can I use synthetic oil in my 2013 Audi Q7?

Yes. 5W-40 is widely available as a full synthetic, and synthetic is safe (often recommended) for the 2013 Audi Q7. What matters most is matching the factory viscosity and specification, then changing the oil and filter on schedule.

Other Audi Q7 years

2025 Q72024 Q72023 Q72022 Q72021 Q72020 Q72019 Q72018 Q72017 Q72015 Q72014 Q72012 Q72011 Q72010 Q72009 Q72008 Q72007 Q7

Other Audi models

100200400050008090A3A3 QuattroA3 Sportback e-tronA4A4 allroadA4 QuattroA5A5 QuattroA5 SportbackA6A6 allroadA6 QuattroA7A7 e QuattroA7 QuattroA8A8 e QuattroA8 QuattroallroadCabrioletCoupeCoupe QuattroQ3Q3 QuattroQ5Q5 eQ5 SportbackQ8QuattroR8RS 3RS 4RS 5RS 5 SportbackRS 6RS 6 AvantRS 7RS 7 SportbackRS Q8S3S4S5S5 SportbackS6S7S8SQ5SQ5 SportbackSQ7SQ8TTTT QuattroTTSV8 Quattro