2010 Audi Q7 Oil Type & Capacity
The 2010 Audi Q7 oil type depends on the engine: the 3.0 TDI takes 5W-40 (8.6 quarts qt with filter); the 3.6 takes 5W-40 (7.3 quarts qt with filter); the 4.2 takes 5W-40 (9.6 quarts qt with filter), per the factory service manual.
Factory-spec answer
It depends on the engine:
- 3.0 TDI: 5W-40, 8.6 quarts with filter
- 3.6: 5W-40, 7.3 quarts with filter
- 4.2: 5W-40, 9.6 quarts with filter
Oil capacity by engine
| Engine | Oil Type (viscosity) | Capacity w/ Filter | Capacity w/o Filter | Notes |
|---|---|---|---|---|
| 3.0 TDI — 3.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 507 00. See TSB No. 17 09-07 (2012855). | 8.60 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 3.6 — 3.6L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 7.30 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 4.2 — 4.2L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 9.60 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
Complete Oil Change Bundle for 2010 Audi Q7
Everything you need delivered in one order. Pre-matched to your factory spec (5W-40, 8.6 quarts).
As an Amazon Associate we earn from qualifying purchases. Prices shown are real-time retail estimates.
Buy the right oil & filter for your Q7
🛒 Buy 5W-40 Full Synthetic Oil (8.6 quarts needed) on Amazon💡 Capacity Note: Your 2010 Audi Q7 holds 8.6 quarts with filter. Since standard jugs are 5 quarts, be sure to pick up extra 1-quart bottles or a 2-pack to reach the full mark on the dipstick.
Popular Full Synthetic Brands (5W-40):
As an Amazon Associate we earn from qualifying purchases made through these links.
More factory specs & repair guides for your Q7
🛞 2010 Audi Q7 Tire Size & Pressure →🌧️ 2010 Audi Q7 Wiper Blade Sizes →💡 2010 Audi Q7 Light Bulb Sizes →📖 2010 Audi Q7 Factory Service Manual →All fluid capacities (transmission, coolant, brakes)Powered by factory manual data from our partner network AllOEMManuals.com.
Coolant capacity
9.5 quarts (8.99 L) — Coolant additive G12++. The cooling system has been filled at the factory with permanent coolant which DOES NOT need to be changed. Even in an emergency, if the coolant additive G12++. G12+ or G12 is not available, do not use a different additive. Use plain water instead until you get the correct additive and can restore the correct ratio. This should be done as soon as possible.
Frequently asked questions
What type of oil does a 2010 Audi Q7 take?
It depends on the engine: 3.0 TDI uses 5W-40; 3.6 uses 5W-40; 4.2 uses 5W-40.
What is the oil capacity of a 2010 Audi Q7?
Oil capacity depends on the engine: 3.0 TDI holds 8.6 quarts with filter; 3.6 holds 7.3 quarts with filter; 4.2 holds 9.6 quarts with filter.
How often should I change the oil in my 2010 Audi Q7?
Most 2010 Audi Q7 owners follow a 5,000–7,500 mile interval with conventional oil, or up to 10,000 miles with full synthetic. Always check the oil life monitor if equipped, and consult your owner's manual — Audi recommends intervals based on driving conditions, not just mileage.
Can I use synthetic oil in my 2010 Audi Q7?
Yes. 5W-40 is widely available as a full synthetic, and synthetic is safe (often recommended) for the 2010 Audi Q7. What matters most is matching the factory viscosity and specification, then changing the oil and filter on schedule.