2011 Audi A6 Oil Type & Capacity
The 2011 Audi A6 oil type depends on the engine: the 3.0T Avant Quattro takes 5W-40 (6.9 quarts qt with filter); the 3.0T Quattro takes 5W-40 (6.9 quarts qt with filter); the 3.2 takes 5W-40 (6.9 quarts qt with filter); the 4.2 Quattro takes 5W-40 (9.0 quarts qt with filter), per the factory service manual.
Factory-spec answer
It depends on the engine:
- 3.0T Avant Quattro: 5W-40, 6.9 quarts with filter
- 3.0T Quattro: 5W-40, 6.9 quarts with filter
- 3.2: 5W-40, 6.9 quarts with filter
- 4.2 Quattro: 5W-40, 9.0 quarts with filter
Oil capacity by engine
| Engine | Oil Type (viscosity) | Capacity w/ Filter | Capacity w/o Filter | Notes |
|---|---|---|---|---|
| 3.0T Avant Quattro — 3.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 6.90 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 3.0T Quattro — 3.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 6.90 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 3.2 — 3.2L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 6.90 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 4.2 Quattro — 4.2L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 9.00 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
Complete Oil Change Bundle for 2011 Audi A6
Everything you need delivered in one order. Pre-matched to your factory spec (5W-40, 6.9 quarts).
As an Amazon Associate we earn from qualifying purchases. Prices shown are real-time retail estimates.
Buy the right oil & filter for your A6
🛒 Buy 5W-40 Full Synthetic Oil (6.9 quarts needed) on Amazon💡 Capacity Note: Your 2011 Audi A6 holds 6.9 quarts with filter. Since standard jugs are 5 quarts, be sure to pick up extra 1-quart bottles or a 2-pack to reach the full mark on the dipstick.
Popular Full Synthetic Brands (5W-40):
As an Amazon Associate we earn from qualifying purchases made through these links.
More factory specs & repair guides for your A6
🛞 2011 Audi A6 Tire Size & Pressure →🌧️ 2011 Audi A6 Wiper Blade Sizes →💡 2011 Audi A6 Light Bulb Sizes →📖 2011 Audi A6 Factory Service Manual →All fluid capacities (transmission, coolant, brakes)Powered by factory manual data from our partner network AllOEMManuals.com.
Coolant capacity
10.1 quarts (9.55 L). Part No. G 012 A8G.
Frequently asked questions
What type of oil does a 2011 Audi A6 take?
It depends on the engine: 3.0T Avant Quattro uses 5W-40; 3.0T Quattro uses 5W-40; 3.2 uses 5W-40; 4.2 Quattro uses 5W-40.
What is the oil capacity of a 2011 Audi A6?
Oil capacity depends on the engine: 3.0T Avant Quattro holds 6.9 quarts with filter; 3.0T Quattro holds 6.9 quarts with filter; 3.2 holds 6.9 quarts with filter; 4.2 Quattro holds 9.0 quarts with filter.
How often should I change the oil in my 2011 Audi A6?
Most 2011 Audi A6 owners follow a 5,000–7,500 mile interval with conventional oil, or up to 10,000 miles with full synthetic. Always check the oil life monitor if equipped, and consult your owner's manual — Audi recommends intervals based on driving conditions, not just mileage.
Can I use synthetic oil in my 2011 Audi A6?
Yes. 5W-40 is widely available as a full synthetic, and synthetic is safe (often recommended) for the 2011 Audi A6. What matters most is matching the factory viscosity and specification, then changing the oil and filter on schedule.