2008 Audi TT Oil Type & Capacity
The 2008 Audi TT oil type depends on the engine: the Base, 2D Convertible takes 5W-40 (4.8 quarts qt with filter); the Base, 2D Coupe takes 5W-40 (4.8 quarts qt with filter); the Quattro, 2D Convertible, Automatic DCT takes 5W-40 (5.8 quarts qt with filter); the Quattro, 2D Convertible, Standard takes 5W-40 (5.8 quarts qt with filter); the Quattro, 2D Coupe, Automatic DCT takes 5W-40 (5.8 quarts qt with filter); the Quattro, 2D Coupe, Standard takes 5W-40 (5.8 quarts qt with filter), per the factory service manual.
Factory-spec answer
It depends on the engine:
- Base, 2D Convertible: 5W-40, 4.8 quarts with filter
- Base, 2D Coupe: 5W-40, 4.8 quarts with filter
- Quattro, 2D Convertible, Automatic DCT: 5W-40, 5.8 quarts with filter
- Quattro, 2D Convertible, Standard: 5W-40, 5.8 quarts with filter
- Quattro, 2D Coupe, Automatic DCT: 5W-40, 5.8 quarts with filter
- Quattro, 2D Coupe, Standard: 5W-40, 5.8 quarts with filter
Oil capacity by engine
| Engine | Oil Type (viscosity) | Capacity w/ Filter | Capacity w/o Filter | Notes |
|---|---|---|---|---|
| Base, 2D Convertible — 2.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 4.80 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| Base, 2D Coupe — 2.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 4.80 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| Quattro, 2D Convertible, Automatic DCT — 3.2L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 5.80 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| Quattro, 2D Convertible, Standard — 3.2L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 5.80 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| Quattro, 2D Coupe, Automatic DCT — 3.2L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 5.80 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| Quattro, 2D Coupe, Standard — 3.2L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 5.80 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
Complete Oil Change Bundle for 2008 Audi TT
Everything you need delivered in one order. Pre-matched to your factory spec (5W-40, 4.8 quarts).
As an Amazon Associate we earn from qualifying purchases. Prices shown are real-time retail estimates.
Buy the right oil & filter for your TT
🛒 Buy 5W-40 Full Synthetic Oil (4.8 quarts needed) on AmazonPopular Full Synthetic Brands (5W-40):
As an Amazon Associate we earn from qualifying purchases made through these links.
More factory specs & repair guides for your TT
🛞 2008 Audi TT Tire Size & Pressure →🌧️ 2008 Audi TT Wiper Blade Sizes →💡 2008 Audi TT Light Bulb Sizes →📖 2008 Audi TT Factory Service Manual →All fluid capacities (transmission, coolant, brakes)Powered by factory manual data from our partner network AllOEMManuals.com.
Coolant capacity
9.5 quarts (8.99 L)
Frequently asked questions
What type of oil does a 2008 Audi TT take?
It depends on the engine: Base, 2D Convertible uses 5W-40; Base, 2D Coupe uses 5W-40; Quattro, 2D Convertible, Automatic DCT uses 5W-40; Quattro, 2D Convertible, Standard uses 5W-40; Quattro, 2D Coupe, Automatic DCT uses 5W-40; Quattro, 2D Coupe, Standard uses 5W-40.
What is the oil capacity of a 2008 Audi TT?
Oil capacity depends on the engine: Base, 2D Convertible holds 4.8 quarts with filter; Base, 2D Coupe holds 4.8 quarts with filter; Quattro, 2D Convertible, Automatic DCT holds 5.8 quarts with filter; Quattro, 2D Convertible, Standard holds 5.8 quarts with filter; Quattro, 2D Coupe, Automatic DCT holds 5.8 quarts with filter; Quattro, 2D Coupe, Standard holds 5.8 quarts with filter.
How often should I change the oil in my 2008 Audi TT?
Most 2008 Audi TT owners follow a 5,000–7,500 mile interval with conventional oil, or up to 10,000 miles with full synthetic. Always check the oil life monitor if equipped, and consult your owner's manual — Audi recommends intervals based on driving conditions, not just mileage.
Can I use synthetic oil in my 2008 Audi TT?
Yes. 5W-40 is widely available as a full synthetic, and synthetic is safe (often recommended) for the 2008 Audi TT. What matters most is matching the factory viscosity and specification, then changing the oil and filter on schedule.