2015 Audi R8 Oil Type & Capacity
The 2015 Audi R8 oil type depends on the engine: the 4.2L takes 5W-40 (10.6 quarts with filter); the 4.2L takes 5W-40 (10.6 quarts with filter); the 4.2L takes 5W-40 (10.6 quarts with filter); the 4.2L takes 5W-40 (10.6 quarts with filter); the 5.2L takes 10W-60 (8.8 quarts with filter); the 5.2L takes 10W-60 (8.8 quarts with filter); the 5.2L takes 10W-60 (8.8 quarts with filter); the 5.2L takes 10W-60 (8.8 quarts with filter); the Plus, Automatic DCT Trans takes 10W-60 (8.8 quarts with filter); the Plus, Standard Trans takes 10W-60 (8.8 quarts with filter), per the factory service manual.
Factory-spec answer
It depends on the engine:
- 4.2L: 5W-40, 10.6 quarts with filter
- 4.2L: 5W-40, 10.6 quarts with filter
- 4.2L: 5W-40, 10.6 quarts with filter
- 4.2L: 5W-40, 10.6 quarts with filter
- 5.2L: 10W-60, 8.8 quarts with filter
- 5.2L: 10W-60, 8.8 quarts with filter
- 5.2L: 10W-60, 8.8 quarts with filter
- 5.2L: 10W-60, 8.8 quarts with filter
- Plus, Automatic DCT Trans: 10W-60, 8.8 quarts with filter
- Plus, Standard Trans: 10W-60, 8.8 quarts with filter
Oil capacity by engine
| Engine | Oil Type (viscosity) | Capacity w/ Filter | Capacity w/o Filter | Notes |
|---|---|---|---|---|
| 4.2L — 4.2L Eng | SAE 5W-40 or 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043 | 10.60 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 4.2L — 4.2L Eng | SAE 5W-40 or 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043 | 10.60 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 4.2L — 4.2L Eng | SAE 5W-40 or 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043 | 10.60 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 4.2L — 4.2L Eng | SAE 5W-40 or 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043 | 10.60 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 5.2L — 5.2L Eng | Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 501 01 or 505 00, SAE 10W-60 G 052 194 See TSB No. 17 09-07 (2012855). | 8.80 QTS. | — | — |
| 5.2L — 5.2L Eng | Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 501 01 or 505 00, SAE 10W-60 G 052 194 See TSB No. 17 09-07 (2012855). | 8.80 QTS. | — | — |
| 5.2L — 5.2L Eng | Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 501 01 or 505 00, SAE 10W-60 G 052 194 See TSB No. 17 09-07 (2012855). | 8.80 QTS. | — | — |
| 5.2L — 5.2L Eng | Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 501 01 or 505 00, SAE 10W-60 G 052 194 See TSB No. 17 09-07 (2012855). | 8.80 QTS. | — | — |
| Plus, Automatic DCT Trans — 5.2L Eng | Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 501 01 or 505 00, SAE 10W-60 G 052 194 See TSB No. 17 09-07 (2012855). | 8.80 QTS. | — | — |
| Plus, Standard Trans — 5.2L Eng | Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 501 01 or 505 00, SAE 10W-60 G 052 194 See TSB No. 17 09-07 (2012855). | 8.80 QTS. | — | — |
Buy the right oil
Buy 5W-40 motor oil on AmazonBuy 10W-60 motor oil on Amazon2015 Audi R8 oil filter on AmazonAs an Amazon Associate we earn from qualifying purchases made through these links.
More specs & repair guides for your R8
2015 Audi R8 factory service manualAll fluid capacities (transmission, coolant, brakes)Powered by factory manual data from our partner site AllOEMManuals.com.
Coolant capacity
25.3 quarts (23.94 L) — G13 TL-VW774J. Dilute with distilled water.
Frequently asked questions
What type of oil does a 2015 Audi R8 take?
It depends on the engine: 4.2L uses 5W-40; 4.2L uses 5W-40; 4.2L uses 5W-40; 4.2L uses 5W-40; 5.2L uses 10W-60; 5.2L uses 10W-60; 5.2L uses 10W-60; 5.2L uses 10W-60; Plus, Automatic DCT Trans uses 10W-60; Plus, Standard Trans uses 10W-60.
How much oil does a 2015 Audi R8 take?
Capacity depends on the engine: 4.2L holds 10.6 quarts with filter; 4.2L holds 10.6 quarts with filter; 4.2L holds 10.6 quarts with filter; 4.2L holds 10.6 quarts with filter; 5.2L holds 8.8 quarts with filter; 5.2L holds 8.8 quarts with filter; 5.2L holds 8.8 quarts with filter; 5.2L holds 8.8 quarts with filter; Plus, Automatic DCT Trans holds 8.8 quarts with filter; Plus, Standard Trans holds 8.8 quarts with filter.
Can I use synthetic oil in my 2015 Audi R8?
Yes. 5W-40 is widely available as a full synthetic, and synthetic is safe (often recommended) for the 2015 Audi R8. What matters most is matching the factory viscosity and specification, then changing the oil and filter on schedule.
Other Audi R8 years
Other Audi models
100200400050008090A3A3 QuattroA3 Sportback e-tronA4A4 allroadA4 QuattroA5A5 QuattroA5 SportbackA6A6 allroadA6 QuattroA7A7 e QuattroA7 QuattroA8A8 e QuattroA8 QuattroallroadCabrioletCoupeCoupe QuattroQ3Q3 QuattroQ5Q5 eQ5 SportbackQ7Q8QuattroRS 3RS 4RS 5RS 5 SportbackRS 6RS 6 AvantRS 7RS 7 SportbackRS Q8S3S4S5S5 SportbackS6S7S8SQ5SQ5 SportbackSQ7SQ8TTTT QuattroTTSV8 Quattro