2013 Audi Q5 Oil Type & Capacity
The 2013 Audi Q5 oil type depends on the engine: the 2.0L takes 5W-40 (4.9 quarts qt with filter); the 3.0L takes 5W-40 (7.2 quarts qt with filter); the Hybrid Prestige takes 5W-40 (4.9 quarts qt with filter); the Premium takes 5W-40 (4.9 quarts qt with filter); the Prestige takes 5W-40 (7.2 quarts qt with filter), per the factory service manual.
Factory-spec answer
It depends on the engine:
- 2.0L: 5W-40, 4.9 quarts with filter
- 3.0L: 5W-40, 7.2 quarts with filter
- Hybrid Prestige: 5W-40, 4.9 quarts with filter
- Premium: 5W-40, 4.9 quarts with filter
- Prestige: 5W-40, 7.2 quarts with filter
Oil capacity by engine
| Engine | Oil Type (viscosity) | Capacity w/ Filter | Capacity w/o Filter | Notes |
|---|---|---|---|---|
| 2.0L — 2.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043. | 4.90 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 3.0L — 3.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043. | 7.20 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| Hybrid Prestige — 2.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043. | 4.90 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| Premium — 2.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043. | 4.90 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| Prestige — 3.0L Eng | SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043. | 7.20 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
📦 DIY Oil Change Kit Builder
Complete Oil Change Bundle for 2013 Audi Q5
Everything you need delivered in one order. Pre-matched to your factory spec (5W-40, 4.9 quarts).
Preferred Oil Brand:
Mobil 1 5W-40 Full Synthetic OilExact Spec
5-Quart Jug (4.9 quarts needed)
$27.97Item Link ↗
2013 Audi Q5 Premium Synthetic Oil FilterExact Fit
OEM-fitment high-efficiency synthetic filter media (2.0L)
$11.99Item Link ↗
Oil Drain Plug Crush Washer Gaskets (5-Pack)Recommended
Direct-fit replacement seal — prevents oil leaks after tightening
$6.99Item Link ↗
15-Quart Low-Profile Drain Pan with Pour SpoutTool
Catch-all basin with anti-splash lip & secure transport cap
$18.99Item Link ↗
RhinoRamps 12,000 lb Drive-Up Vehicle RampsTool
Safe driveway clearance for quick vehicle underbody access
$49.99Item Link ↗
Heavy-Duty Black Nitrile Gloves (Box of 100)PPE
6-mil commercial-grade chemical & oil resistant mechanics gloves
$14.99Item Link ↗
Multi-Angle Spill-Proof Oil Funnel SetTool
Wide-mouth funnel with flexible neck to eliminate engine bay spills
$8.99Item Link ↗
Scott Blue Shop Towels (6-Pack)Supplies
Ultra-absorbent lint-free automotive towels for clean-up
$12.99Item Link ↗
Selected Items: 3 items
$46.95 est. total
As an Amazon Associate we earn from qualifying purchases. Prices shown are real-time retail estimates.
Buy the right oil & filter for your Q5
🛒 Buy 5W-40 Full Synthetic Oil (4.9 quarts needed) on AmazonPopular Full Synthetic Brands (5W-40):
As an Amazon Associate we earn from qualifying purchases made through these links.
More factory specs & repair guides for your Q5
🛞 2013 Audi Q5 Tire Size & Pressure →🌧️ 2013 Audi Q5 Wiper Blade Sizes →💡 2013 Audi Q5 Light Bulb Sizes →📖 2013 Audi Q5 Factory Service Manual →All fluid capacities (transmission, coolant, brakes)Powered by factory manual data from our partner network AllOEMManuals.com.
Coolant capacity
10.5 quarts (9.93 L). Part No. G 012 A8G.
Frequently asked questions
What type of oil does a 2013 Audi Q5 take?
It depends on the engine: 2.0L uses 5W-40; 3.0L uses 5W-40; Hybrid Prestige uses 5W-40; Premium uses 5W-40; Prestige uses 5W-40.
What is the oil capacity of a 2013 Audi Q5?
Oil capacity depends on the engine: 2.0L holds 4.9 quarts with filter; 3.0L holds 7.2 quarts with filter; Hybrid Prestige holds 4.9 quarts with filter; Premium holds 4.9 quarts with filter; Prestige holds 7.2 quarts with filter.
How often should I change the oil in my 2013 Audi Q5?
Most 2013 Audi Q5 owners follow a 5,000–7,500 mile interval with conventional oil, or up to 10,000 miles with full synthetic. Always check the oil life monitor if equipped, and consult your owner's manual — Audi recommends intervals based on driving conditions, not just mileage.
Can I use synthetic oil in my 2013 Audi Q5?
Yes. 5W-40 is widely available as a full synthetic, and synthetic is safe (often recommended) for the 2013 Audi Q5. What matters most is matching the factory viscosity and specification, then changing the oil and filter on schedule.
Other Audi Q5 years
2025 Q52024 Q52023 Q52022 Q52021 Q52020 Q52019 Q52018 Q52017 Q52016 Q52015 Q52014 Q52012 Q52011 Q52010 Q52009 Q5
Other Audi models
100200400050008090A3A3 QuattroA3 Sportback e-tronA4A4 allroadA4 QuattroA5A5 QuattroA5 SportbackA6A6 allroadA6 QuattroA7A7 e QuattroA7 QuattroA8A8 e QuattroA8 QuattroallroadCabrioletCoupeCoupe QuattroQ3Q3 QuattroQ5 eQ5 SportbackQ7Q8QuattroR8RS 3RS 4RS 5RS 5 SportbackRS 6RS 6 AvantRS 7RS 7 SportbackRS Q8S3S4S5S5 SportbackS6S7S8SQ5SQ5 SportbackSQ7SQ8TTTT QuattroTTSV8 Quattro