2005 Audi allroad Oil Type & Capacity
The 2005 Audi allroad oil type depends on the engine: the 2.7 D, Automatic takes 0W-30 (6.9 quarts qt with filter); the 2.7 D, Standard takes 0W-30 (6.9 quarts qt with filter); the 4.2 L takes 0W-30 (8.5 quarts qt with filter), per the factory service manual.
Factory-spec answer
It depends on the engine:
- 2.7 D, Automatic: 0W-30, 6.9 quarts with filter
- 2.7 D, Standard: 0W-30, 6.9 quarts with filter
- 4.2 L: 0W-30, 8.5 quarts with filter
Oil capacity by engine
| Engine | Oil Type (viscosity) | Capacity w/ Filter | Capacity w/o Filter | Notes |
|---|---|---|---|---|
| 2.7 D, Automatic — 2.7L Eng | SAE 0W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 6.90 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 2.7 D, Standard — 2.7L Eng | SAE 0W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 6.90 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
| 4.2 L — 4.2L Eng | SAE 0W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 8.50 QTS. | — | Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill. |
More factory specs & repair guides for your allroad
🛞 2005 Audi allroad Tire Size & Pressure →🌧️ 2005 Audi allroad Wiper Blade Sizes →💡 2005 Audi allroad Light Bulb Sizes →📖 2005 Audi allroad Factory Service Manual →All fluid capacities (transmission, coolant, brakes)Powered by factory manual data from our partner network AllOEMManuals.com.
Coolant capacity
6.3 quarts (5.96 L) — Phosphate Free Coolant., G 012 A8F A4 (Purple Colored). DO NOT interchange or mix older G 011 A8 C or G 012 A8 D with G 012 A8F A4. This can result in serious damage to the engine.
Frequently asked questions
What type of oil does a 2005 Audi allroad take?
It depends on the engine: 2.7 D, Automatic uses 0W-30; 2.7 D, Standard uses 0W-30; 4.2 L uses 0W-30.
What is the oil capacity of a 2005 Audi allroad?
Oil capacity depends on the engine: 2.7 D, Automatic holds 6.9 quarts with filter; 2.7 D, Standard holds 6.9 quarts with filter; 4.2 L holds 8.5 quarts with filter.
How often should I change the oil in my 2005 Audi allroad?
Most 2005 Audi allroad owners follow a 5,000–7,500 mile interval with conventional oil, or up to 10,000 miles with full synthetic. Always check the oil life monitor if equipped, and consult your owner's manual — Audi recommends intervals based on driving conditions, not just mileage.
Can I use synthetic oil in my 2005 Audi allroad?
Yes. 0W-30 is widely available as a full synthetic, and synthetic is safe (often recommended) for the 2005 Audi allroad. What matters most is matching the factory viscosity and specification, then changing the oil and filter on schedule.