2000 Volkswagen Cabrio Oil Type & Capacity
The 2000 Volkswagen Cabrio takes 5W-40 motor oil — 4.2 quarts with a filter change, per the factory service manual.
Factory-spec answer
5W-40 — 4.2 quarts with filter
Oil capacity by engine
| Engine | Oil Type (viscosity) | Capacity w/ Filter | Capacity w/o Filter | Notes |
|---|---|---|---|---|
| GL, Automatic | SAE 5W-40 or SAE 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 4.20 QTS. | — | Use only a high-quality engine oil that expressly complies with the Volkswagen oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any Volkswagen Limited Warranty. DO NOT mix any lubricants or other additives into the engine oil. Doing so can cause engine damage. Damage caused by these kinds of additives are not covered by any Volkswagen Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. |
| GL, Standard | SAE 5W-40 or SAE 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 4.20 QTS. | — | Use only a high-quality engine oil that expressly complies with the Volkswagen oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any Volkswagen Limited Warranty. DO NOT mix any lubricants or other additives into the engine oil. Doing so can cause engine damage. Damage caused by these kinds of additives are not covered by any Volkswagen Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. |
| GLS, Automatic | SAE 5W-40 or SAE 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 4.20 QTS. | — | Use only a high-quality engine oil that expressly complies with the Volkswagen oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any Volkswagen Limited Warranty. DO NOT mix any lubricants or other additives into the engine oil. Doing so can cause engine damage. Damage caused by these kinds of additives are not covered by any Volkswagen Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. |
| GLS, Standard | SAE 5W-40 or SAE 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). | 4.20 QTS. | — | Use only a high-quality engine oil that expressly complies with the Volkswagen oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any Volkswagen Limited Warranty. DO NOT mix any lubricants or other additives into the engine oil. Doing so can cause engine damage. Damage caused by these kinds of additives are not covered by any Volkswagen Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. |
Buy the right oil
Buy 5W-40 motor oil on Amazon2000 Volkswagen Cabrio oil filter on AmazonAs an Amazon Associate we earn from qualifying purchases made through these links.
More specs & repair guides for your Cabrio
2000 Volkswagen Cabrio factory service manualAll fluid capacities (transmission, coolant, brakes)Powered by factory manual data from our partner site AllOEMManuals.com.
Coolant capacity
5.3 quarts (5.01 L) — Phosphate free coolant G12. DO NOT interchange or mix older G11 and G12 coolant.
Frequently asked questions
What type of oil does a 2000 Volkswagen Cabrio take?
The 2000 Volkswagen Cabrio takes 5W-40 motor oil (SAE 5W-40 or SAE 5W-30. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855).), per the factory service manual.
How much oil does a 2000 Volkswagen Cabrio take?
The 2000 Volkswagen Cabrio holds 4.2 quarts with a filter change.
Can I use synthetic oil in my 2000 Volkswagen Cabrio?
Yes. 5W-40 is widely available as a full synthetic, and synthetic is safe (often recommended) for the 2000 Volkswagen Cabrio. What matters most is matching the factory viscosity and specification, then changing the oil and filter on schedule.